VERTICAL
HOT WATER STORAGE TANKS
T120V, T200V
FEATURES
A.O. Smith storage tanks are ideal for use with
gas-fired copper heat exchanger equipment for
storage of any potable water at temperatures of
180°F (82°C) or lower.
GLASS-LINED TANK - Alkaline borosilicate
composition permanently fused to steel by firing
at a temperature of 1600°F (870°C), providing
years of corrosion protection and dependable
use.
MAGNESIUM ANODES - For extra protection.
THREADED OPENINGS - All tanks furnished
with threaded openings for thermometer,
tankstat, drain valve, relief valve plus 2" NPT
recirculation lines.
SMALL FOOTPRINT - Compact. Fits through
30" door.
L
W
CRN
WORKING PRESSURE 150 PSI (1030 kPa)
HANDHOLE CLEANOUT - Standard on T200V.
OPTIONS
(ON ASME CONSTRUCTED TANKS)
LIMITED WARRANTY OUTLINE
If the tank should leak any time during the first
three years, under the terms of the warranty,
A. O. Smith will repair or replace the tank;
installation, labor, handling and local delivery
extra. THIS OUTLINE IS NOT A WARRANTY.
For complete information, consult the written
warranty or A. O. Smith Enterprises Ltd.
Perfectly balanced manifold kits allow installation
where up to 4 tanks are required.
Insulation kits for field installation.
May 2000
A 408.0C
Dimensions in inches (mm)
Shipping
Weight
Model
No.
Capacity
Gals (Liters)
A
B
C
D
E
F
G
Lbs (Kgs)
T-120V
T-200V
119 (450)
188 (710)
60.75 (1543) 42 (1067) 24 (610) 4 (102) 10.9 (276) 15.5 (394)
4 (102)
270 (123)
75 (1905)
63.5 (1613) 28 (711) 12 (305) 13.3 (330) 17 (432) 11.4 (289) 421 (191)
SUGGESTED SPECIFICATIONS
Glass-lined storage tank(s) shall be A.O. SMITH glass-lined storage tank(s) or equal. Tanks shall be _______" (mm) x _______" (mm) and
have a nominal capacity of ___ gallons (liters). Tank(s) shall have threaded openings as shown on drawings. Exterior of tank(s) shall be
thoroughly cleaned and painted. Interior of tank(s) shall be glass-lined with an alkaline borosilicate composition which has been fused to the
steel base by firing at a temperature of 1600°F (870°C). All internal surfaces exposed to water are glass-lined per ASME HLW code
procedures using an NSF approved glass lining compound with nickelous oxide. Cathodic protection shall be provided. They shall have a
working pressure of 150 psi (1030 kPa). Tank shall have a three year limited warranty as outlined in the written warranty.
A. O. Smith Enterprises Ltd.
Water Products Company
A Subsidiary of A. O. Smith Corporation Renton, Washington
El Paso, Texas
McBee, South Carolina
A.O. Smith Water Products Co., Inc. On Line
Stratford, Ontario
Veldhoven, The Netherlands
For Technical Information and
Automated Fax Service,
Phone: 800-527-1953
A. O. Smith Corporation reserves the right to make product changes
or improvements at any time without notice.
© A. O. Smith Corp., 2000
Printed in U.S.A.
A 409.0C
|