Commercial Storage Tanks
FACTORY JACKETED AND
INSULATED STORAGE TANKS
These A. O. Smith storage tanks are designed for storing potable water. Fitting locations
MODELS
TJ-80S, TJ-80A
TJV-120A, TJV-120M
& TJV-200M
are designed to meet the needs of normal installations plus those
®
for the A. O. Smith Cer-Temp 80 and Shure-Temp piping methods.
FEATURES
MEETS ASHRAE/IESNA 90.1-2004.
A. O. Smith storage tanks are ideal for use with gas-fired copper heat exchanger equipment
for storage of any potable water at temperatures up to 180°F.
GLASS-LINED TANK - Alkaline borosilicate composition permanently fused to steel by
firing at a temperature of 1600°F, providing years of corrosion protection and
dependable use.
HEAVY GAUGE STEEL JACKET - With baked enamel finish.
THREADED OPENINGS - All tanks furnished with threaded openings for thermometer,
relief valve, 2” recirculation lines, tankstat, and drain valve.
5 YEAR WARRANTY
If the tank should leak any time during the first 5 years, under the terms of the warranty,
A. O. Smith will repair or replace the tank. Installation, labor, handling and local delivery are extra.
For complete information, consult the written warranty or contact A. O. Smith.
TJ-80S, TJ-80A, TJV-120M and TJV-120A
• Fits through 30” door
• Magnesium anode for anti-corrosion protection
TJ-80A • 80 gallons • exceeds ASHRAE requirements •
saves fuel, helps reduce standby heat loss • 160 psi ASME
standard working pressure.
TJV-120A • 119 gallons • exceeds ASHRAE requirements • saves fuel, helps reduce
standby heat loss • 160 psi ASME standard working pressure.
TJ-80S • 80 gallons • exceeds ASHRAE requirements • 150 psi working pressure.
120 Gallon Model
TJV-120M • 119 gallons • exceeds ASHRAE requirements
• 150 psi working pressure.
OPTIONS
Perfectly balanced manifold kits (120 gallon models) allow
installation where 240 to 480 gallons of stored water is
required.
TJV-200-M - 175 GALLONS
• 150 psi ASME working pressure
• 2” foam insulation
(FOR SELECT MODELS)
• Handhole cleanout (Standard)
• Fits through 33” door
• Storage is downsized to 175 gallons for a 32” x 77” envelope for space restrictive
installations. Model TJV-200 is available with 200 gallons of storage
• Magnesium anodes for extra corrosion protection.
Page 1 of 2
Revised August 2008
AOSTT35100
Download from Www.Somanuals.com. All Manuals Search And Download.
Commercial Storage Tanks
SUGGESTED SPECIFICATION
Storage tank shall be A. O. SMITH glass-lined storage tank. Tank shall be _______” x _______” and have a nominal capacity of ____ gallons. Tank(s) shall
have threaded openings as shown on drawings. Interior of tank(s) shall be glasslined with an alkaline borosilicate composition which has been fused to the
steel by firing at a temperature of 1600°F. Glass coating shall be continuous over the entire inner surface of the tank. Outer jacket shall have a baked enamel
finish. Foam insulation to meet or exceed ASHRAE 90.1-2004 efficiency requirements. Cathodic protection shall be provided. Tank shall have a working
pressure of ____ psi. Tank shall have a five year limited warranty as outlined in the written warranty.
For Technical Information and Automated Fax Service, call 800-527-1953. A.O. Smith Corporation reserves the right to make product changes or improvements without prior notice.
Revised August 2008
Page 2 of 2
AOSTT35100
Download from Www.Somanuals.com. All Manuals Search And Download.
|